Samsung SRP-275 Manual do Operador descarregar pdf (Página 71)

5-735-72

GS r

[Name] Transmit status

[Format] ASCII GS r n

Hex 1D 72 n

Decimal 29 114 n

[Range] n = 1, 2, 49, 50

[Description] Transmits 1 byte of status data using n as follows:

1, 49

2, 50

Function

Transmits paper sensor status

Transmits drawer kick-out connector status

[Notes] Each status is 1 byte.

The status to be transmitted is as follows:

- Paper sensor status (n = 1, 49)

The status to be transmitted is as follows:

- Drawer kick-out connector status (n = 2, 50)

When you use this command, obey the following rules.

- After the host PC transmits the function data, the printer will send

response data or status data back to the PC. Do not transmit more data

from the PC until the response data or status data are received from the

printer.

- When operating with a serial interface, be sure to configure operation so

that the host computer uses the printer only when it is READY.

- With a parallel interface, a real-time status is stored in the transmission

buffer of the printer temporarily the same as the other transmission data

(except for ASB status), and when the host enters reverse mode, data is

transmitted in order from the beginning of the transmission buffer.

Bit Binary Hex Decimal Status

5,6

Paper near-end sensor: paper adequate.

Paper near-end sensor: paper not present.

Paper end sensor: paper present.

Paper end sensor: paper not present.

Not used. Fixed to Off.

Undefined.

Not used. Fixed to Off.

Bit Binary Hex Decimal Status

1-3

5,6

Drawer kick-out connector pin 3 is LOW.

Drawer kick-out connector pin 3 is HIGH.

Undefined.

Not used. Fixed to Off.

Undefined

Not used. Fixed to Off.

CONTROL COMMANDS LIST

CHAPTER 5

0,1

2,3

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 109 110

Comentários a estes Manuais

Sem comentários

Samsung SRP-275 Manual do Operador Página 71

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Samsung SRP-275