Samsung SONOACE R5 Manual do Utilizador descarregar pdf (Página 141)

5-17

Chapter 5 Measurements And Calculations

2. Specify two points and measure the straight distance between them. The method for measuring a

line is the same as in “2D Distance (Line).”

3. When the measurement is nished, its result is shown on the screen. The volume of the object

along with the length of the straight line are calculated.

The equations used for 1 Distance measurement are as follows:

, (D: distance)

Distance + Ellipse

This is a basic measurement that is available in all diagnosis modes. You can measure the volume of an

object in a 2D image by using one straight line and one circle (ellipse).

You can measure up to 2 sets of volumes. When measuring more than one set, use measurement

cursors with dierent shapes to dierentiate them.

1. Use the Softmenu switch [3] Volume to select 3D Volume: Distance + Ellipse. “3D Volume: Distance

+ Ellipse” is displayed on the left side of the screen.

2. Specify two points and measure the straight distance between them. The method for measuring a

line is the same as in “2D Distance (Line).”

3. Specify the size of the circle (ellipse). The method for measuring a circle (ellipse) is the same as in

“2D Ellipse.”

4. When the measurement is nished, its result is shown on the screen.

X

D.: Length of Straight Line

X

A: Length of A-axis in Ellipse

X

B: Length of B-axis in Ellipse

X

V: Volume of Circle (Ellipse)

The equations used for Distance + Ellipse measurement are as follows:

NOTE: Since Dual Mode simultaneously displays two images on the screen, you don’t have to

return to the diagnosis mode to measure volume in Dual Mode.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 291 292

Sem comentários

Samsung SONOACE R5 Manual do Utilizador Página 141