Samsung SONOACE R5 Manual do Utilizador descarregar pdf (Página 134)

5-10

Operation Manual

2. Use the trackball and the Set button on the control panel to specify both end points of the

measurement area.

X

Place the cursor at a desired position with the trackball, and press the Set button.

Tips!

Repositioning Point

Pressing the Change button before pressing the Set button to complete positioning resets the

position of a point just set.

3. If you specify both end points, the distance between them will be automatically calculated.

4. When the measurement is nished, its result is shown on the screen.

2D Distance (Trace)

It is a basic measurement that is available in all diagnosis modes. You can specify a point in a 2D image

and trace a curve from that point to measure the distance between them.

You can measure up to 4 distances. When taking more than one measurement, use measurement

cursors with dierent shapes to dierentiate them.

1. Use the Softmenu switch [1] Line Trace to select 2D Distance (Trace). “2D Distance (Trace)” is

displayed on the left side of the screen.

2. Use the trackball and the Set button on the control panel to specify the start point of the

measurement area.

X

Place the cursor at a desired position with the trackball, and press the Set button.

3. With the trackball, draw a desired curve and press the Set button to specify the end point.

4. If you specify both end points, the length of the curve will be automatically calculated.

5. When the measurement is nished, its result is shown on the screen.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 291 292

Sem comentários

Samsung SONOACE R5 Manual do Utilizador Página 134