Samsung SONOACE R5 Manual do Utilizador descarregar pdf (Página 133)

5-9

Chapter 5 Measurements And Calculations

Basic Measurement Operations

The following is the information on common button operations for basic measurements:

[Figure 5.1 Basic Measurement – Softmenu]

■

Select/Change Measurement Method

Use the Softmenu switch on the control panel. The Softmenu items displayed vary depending on

the diagnosis mode. The selected measurement method is displayed in the user information area.

■

Delete Measurement Result

Press the Clear button on the control panel.

■

Print Measurement Result

Press the Print button on the control panel.

■

Finish Basic Measurements

Press the Exit button on the control panel.

NOTE: To change various settings such as measurement units, press the Setup key on the

keyboard and select Measure > General > General. For more information, please refer to

‘Chapter 7. Utilites.’

Distance Measurement

2D Distance (Line)

This is a basic measurement that is available in all diagnosis modes. You can specify two points in a 2D

image and measure the straight distance between them.

You can measure up to 4 distances. When taking more than one measurement, use measurement

cursors with dierent shapes to dierentiate them.

1. Use the Softmenu switch [1] Distance to select 2D Distance (Line). “2D Distance (Line)” is displayed

on the left side of the screen.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 291 292

Sem comentários

Samsung SONOACE R5 Manual do Utilizador Página 133