Samsung SONOACE R5 Manual do Utilizador descarregar pdf (Página 140)

5-16

Operation Manual

The equations used for Trace measurement are as follows:

, (N = 1,2… last point)

Volume Measurement

3 Distance

This is a basic measurement that is available in all diagnosis modes. You can measure the volume of an

object in a 2D image by using 3 straight lines.

1. Use the Softmenu switch [3] Volume to select 3D Volume: 3 Distance. “3D Volume: 3 Distance” is

displayed on the left side of the screen.

2. Specify two points and measure the straight distance between them. The method for measuring a

line is the same as in “2D Distance (Line).”

3. Measure the length of the remaining two straight lines as in the above. Measure other two distance

using the same method with 2.

4. When the measurement is nished, its result is shown on the screen. The volume of the object

along with the length of each straight line are calculated.

The equations used for 3 Distance measurement are as follows:

, (D: distance)

1 Distance

This is a basic measurement that is available in all diagnosis modes. You can measure the volume of an

object in a 2D image by using only one straight line.

You can measure up to 4 sets of volumes. When measuring more than one set, use measurement

cursors with dierent shapes to dierentiate them.

1. Use the Softmenu switch [3] Volume to select 3D Volume: 1 Distance. “3D Volume: 1 Distance” is

displayed on the left side of the screen.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 291 292

Sem comentários

Samsung SONOACE R5 Manual do Utilizador Página 140