Samsung ACCUVIX XG Manual do Utilizador descarregar pdf (Página 261)

5-21

Chapter 5 Measurements and Calculations

4. Once measurement is done, the result is displayed on the screen.

Tips!

Editing Curves

Before specifying the end point by pressing the Set button, you can delete part of the curve being

traced by rotating the [5] Delete dial-button on the softmenu.

1 Distance Vol.

This is a basic measurement that is available in all diagnosis modes. You can measure the volume of

an object in a 2D image by using only one straight line.

1. Press the 1 Distance Vol. button on the touch screen. “1 Distance” is displayed in the user

information area.

2. Specify two points and measure the straight distance between them. The method for measuring

a line is the same as in “Distance.”

3. When the measurement is nished, its result is shown on the screen. The volume of the object

along with the length of the straight line are calculated.

The equations used for 1 Distance measurement are as follows:

Ellipse Vol.

A basic measurement that is available in all diagnosis modes. In a 2D image, the volume of a conical

object is measured using an ellipse.

1. Tap the Ellipse Vol. on the touch screen. ‘Ellipse’ will appear in the user information area.

2. Set the size of the ellipse. The way it is measured is the same as in ‘Ellipse.’

3. Once measurement is done, the result is displayed on the screen.

The following equation is used for ‘Ellipse’ measurement:

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 373 374

Sem comentários

Samsung ACCUVIX XG Manual do Utilizador Página 261