
4-11
Chapter 4 Diagnosis Modes
■
SRF Index
Tap SRF Index on the touch screen. Set the SRF index to 1, 2 or 3 by pressing a desired button or
using the dial-button on the touch screen.
NOTE: When SRF is used, the Edge Enhance button is not available.
■
DynamicMR
Turn it on or off by tapping DynamicMR on the touch screen. The ‘DMR’ mark will be displayed in
the image data.
You can obtain a clearer image by eliminating noise and enhancing boundaries. Five pre-configured
indices are provided.
If it is turned on, DMR Index is enabled on the touch screen.
NOTE:
X
Connect a dongle to the console before using DynamicMR. (Dongles can be purchased
separately from the product.)
X
For information on installing a dongle, please refer to the DynamicMR User Manual.
■
DMR+Index (Optional)
Tap DMR Index on the touch screen. Select an index between 1 - 5 by tapping a desired button or
using the dial-button on the touch screen.
■
Frequency
Tap Frequency on the touch screen.
Use the button to change the frequency of the current probe. Select from Res, Pen and Gen.
X
Res (Resolution): High frequency
X
Gen (General): General frequency
X
Pen (Penetration): Low frequency
The selected frequency is displayed in the title area, allowing you to determine the state of the
current frequency easily.
Comentários a estes Manuais