Samsung H60 Manual do Utilizador descarregar pdf (Página 129)

8-11

Chapter 8 Measurements and Calculations

Distance Measurement

 Distance

This is a basic measurement that is available in all diagnosis modes. Specify two points on a 2D image

and measure the length of the straight line between the points.

1. Select Distance on the monitor or touch screen. Use the trackball and the Set button on the control

panel to specify both end points of the measurement area.

X

Use the trackball to place the cursor at the desired position and then press the Set button.

Tips!

Repositioning Point

Instead of pressing the Set button to conﬁrm the point position, you can press the Change button

to change it.

2. Specify both end points and then the distance between them will be measured.

3. When the measurement is nished, its result is shown on the screen.

 Trace Length

This is a basic measurement that is available in all diagnosis modes. Specify a point on a 2D image and

trace a curve from that point to measure its length.

1. Select Trace Length on the monitor or touch screen. Use the trackball and the Set button on the

control panel to specify the start point of the measurement area.

X

Use the trackball to place the cursor at the desired position and then press the Set button.

2. Use the trackball to draw the desired curve and then press the Set button to set the end point.

Tips!

Editing Curves

Before specifying the end point by pressing the Set button, you can delete part of the curve being

traced by rotating the soft menu dial-button 5 counter-clockwise.

3. Specify both end points and then the length of the curve will be automatically measured.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 255 256

Sem comentários

Samsung H60 Manual do Utilizador Página 129