Samsung H60 Manual do Utilizador descarregar pdf (Página 104)

7-78

Operation Manual

 MagiCut

NOTE:

X

Select this in MPR mode.

X

If MagiCut is enabled, Accept ROI is turned on automatically.

X

After MagiCut is enabled, if the system is switched to a mode other than MPR Mode, MagiCut is

disabled.

The MagiCut screen is displayed on the touch screen. You can cut the parts that are not relevant to

diagnosis away from 3D images. Set the area to cut by using the trackball and the Set button.

 Mode

Set how parts are cut by tapping the corresponding button on the touch screen.

X

Inside Contour: Cuts the inside of the selected area.

X

Outside Contour: Cuts the outside of the selected area.

X

Inside Box: Cuts the inside of the box.

X

Outside Box: Cuts the outside of the box.

X

Small Eraser: Cuts the selected contour line.

X

Big Eraser: Cuts the selected contour line. This uses a thicker contour line than Small Eraser.

 Full Depth

Tap the corresponding button on the touch screen to turn Full Depth on or off. If it is turned on, the

entire area will be cut. If it is turned off, Depth will appear on the touch screen.

 Depth

Set the cut depth. Use the dial-button to select a value between 1 and 100.

 Undo

Cancel the previous task(s).

X

Undo: Cancel the last task.

X

Undo All: Cancel all tasks that have been done so far.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 255 256

Sem comentários

Samsung H60 Manual do Utilizador Página 104