
3-7
Chapter 3 Starting Diagnosis
Probe Selection Screen
Press the Probe button on the control panel to load the Probe Selection screen. From this screen, you
can select an application and change the probe settings. The Probe Selection screen consists of the
following:
1 Connected probe
2 Application list
3 Preset list
4 Userset list
Probe Connection
Be sure to connect or disconnect probes when the power is o to ensure the safety of the system and
the probes.
1. Lift up the probe’s lockdown switch and disconnect the probe.
2. Connect the probe to the probe port.
3. Push down the probe’s lockdown switch to lock it in place.
NOTE: Debris trapped between the probe and the port can cause connection problems. If you
experience a connection problem, attempt to remove any debris and try again.
Comentários a estes Manuais