Samsung SCR-3000 Manual do Utilizador Página 42

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 94
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 41
4-10
4
Alarm Record Setup
The following illustrates the intial setting of the ALARM RECORD SETUP menu.
ALARM SIGNAL DETECTION
You shall select ON to start recording in the event of alarming and select OFF to prevent
recording in the event of alarming. If you set the ALARM SIGNAL DETECTION to ON
and exit the menu, the system will begin recording whenever alarm occurs. To force stop the
recording during the alarm recording, press and hold the STOP(
) button for 3 seconds. Then,
the recording by the current alarm will be stoppted, and the alarm recording will not be per-
formed for the next 5 seconds even if alarm occurs. To completely stop the alarm recording,
go into the menu within that 5 seconds to set the ALARM SIGNAL DETECTION to OFF.
If no action is performed by the user for 5 seconds, the system returns to the alarm recording
mode. [ON/OFF]
ALARM SIGNAL POLARITY
Set to N. C. (Normally Close) when the alarm input is Active High, and set to N.O.(Normally
Open) when the alarm input is Active Low. [N.C./N.O.]
ALARM BUZZER
Set to ON to have the system activate the Buzzer when a motion is deteced in the input
video or when alarm occurs, or set to OFF to keep the Buzzer inactive. [ON/OFF]
MAIN ALARM TIME
Set the duration for which alarm recording is to be performed when a motion is detected in the
input video or when alarm occurs. The value can be set from 0 seconds to 5 minutes when you
set to OFF. If you set to AUTO, the alarm recording is performed only during when the alarm
signal is Active.
[5MINUTE/4MINUTE/3MINUTE/2MINUTE/1MINUTE/30SECOND/20SECOND/
10SECOND/AUTO/OFF]
ALARM RECORD SETUP
ALARM SIGNAL DETECTION OFF
ALARM SIGNAL POLARITY N.O.
ALARM BUZZER ON
MAIN ALARM TIME 10 SECOND
PRE ALARM TIME LIMIT 2 SECOND
POST ALARM TIME LIMIT OFF
MAIN ALARM PICTURE RATE 30.0 FPS
MOTION DETECTION OFF
SET AREA & SENSITIVITY
MOVE=[//
/
] SELECT=[ ] EXIT=[MENU]
Vista de página 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 93 94

Comentários a estes Manuais

Sem comentários