Samsung HS50 Manual do Utilizador descarregar pdf (Página 62)

7-34

User Manual



Exiting PW Spectral Doppler Mode

Press the PW dial-button while the Doppler image is being displayed. You can also press the 2D

dial-button to exit PW Spectral Doppler Mode.

Press the Set button on the control panel to obtain a spectral doppler image.

NOTE: The doppler image can only be obtained in the D Only or Simultaneous states.



PW Spectral Doppler Mode Screen Sample Volume

The doppler spectrum is displayed when the Sample Volume is located above the blood ow

on the 2D image. The size of the Sample Volume is displayed in mm units. Use the trackball to

adjust the position of the Sample Volume.

X

Moving Sample Volume: Use the trackball on the control panel.

X

Resizing Sample Volume: Using the touch screen: Select the SV Size dial-button on the

touch screen.

X

Adjusting Sample Volume Angle: Rotate the Angle dial-button on the control panel to select

a value between -80-80 degrees. Press the Angle dial-button to select either -60, 0, or 60

degrees.



Adjusting Doppler Baseline

Adjust the Baseline by rotating the dial-button on the touch screen.



HPRF (High PRF) Function

Adjust the blood ow above the speed limit at a specic depth. The scale is increased; this can

only be used in PW Spectral Doppler mode (D Only).

NOTE: Setup > Imaging > Common > HPRF

X

Activating HPRF

Increasing the scale at a specic depth to a certain point automatically activates HPRF.

The Phantom Gate will appear on the D Line at a position higher than the sample volume.

Once HPRF starts, PRF does not increase even if you increase the scale value.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 281 282

OSCAR 23 Apr 2025 | 08:21:36

Samsung HS50 Manual do Utilizador Página 62