
4-35
Chapter 4 Diagnosis Modes
■
Magnication
To magnify or reduce the image size, enter Magnication mode by pressing the Magnication
button, and move the Trackball right or left. After checking changed values in the Preview screen,
apply the changes to the entire screen by pressing the Softmenu switch [4] Apply.
Pressing the Exit button applies the changes to the 3D image and exits the Magnication mode.
To activate the Rotation, Position or Cut Mode function while adjusting the image size, press the
corresponding Softmenu switch of each function. To return to the initial image, press the Softmenu
switch [5] INIT 3D.
[Figure 4.14 Softmenu – Magnification Mode]
■
Cut Mode
Press the Cut Mode button on the left side of the screen to enter Cut mode. Determine the area to
cut using the trackball, and press the Set button. Then, the “+” cursor appears. After contouring the
area to cut, press Set button again, and the cutting is nished. To cancel the cutting area, press the
Exit button.
Press the Softmenu switch [1] Inside Contour to outline an area to be cut. The Softmenu switch [2]
Point Eraser function is used to cut a portion of the image. The default setting is Inside Contour.
To cancel cutting, press the Softmenu switch [3] Undo. To redo the cancelled job, press the
Softmenu switch [4] Redo.
To cancel all cuttings and return to the initial 3D screen, press the Softmenu switch [5] Undo All.
[Figure 4.15 Softmenu – Cut Mode]
Comentários a estes Manuais