47
•
AAddjjuusstt tthhee hhoobb ccoonnnneeccttiioonnss::
they are
located under the knobs
(Fig. 04)
.
—
Proceed one tap at a time.
—
Remove the knobs and the gaskets by
pulling them up.
- Switching from natural gas to
butane/propane
-
Using a small flat-head screwdriver,
ssccrreeww iinn
tthhee bbrraassss bbuurrnneerr ppoowweerr
screws (yellow) all the
way,
mmoovviinngg iinn aa cclloocckkwwiissee ddiirreeccttiioonn
(Fig. 05).
-
Replace the gaskets and the knobs, paying
careful attention to their direction and
ensuring that the knobs are pushed in all the
way.
— Switching from butane/propane to natural
gas
-
Unscrew the brass burner power
adjustment screw (yellow)
(Fig. 05)
using a
small, flat-head screwdriver,
ttuurrnn ttwwiiccee iinn aa
ccoouunntteerrcclloocckkwwiissee ddiirreeccttiioonn..
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the
burner power screw
cclloocckkwwiissee
until it reaches
the lowest possible setting that does not
extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to shift from the
maximum flow rate to the minimum:
tthhee ffllaammee
sshhoouulldd nnoott ggoo oouutt;;
if it does, unscrew the
burner power screw so as to obtain good
flame retention during these position
switches.
11 //
INSTALLING YOUR APPLIANCE
Knob
Gasket
Tap
Fig. 05
Tap axis
Fig. 04
Burner power
adjustment screw
Comentários a estes Manuais