Samsung LabelManager Series Guia do Utilizador descarregar pdf (Página 5)

Charging the Battery

A charging adapter is included with your label maker for

recharging the battery pack. Charging the battery pack will

take approximately three hours; however, after charging

for about 10 minutes, the label maker can be used to print

labels.

The charging adapter is only used for recharging the

battery pack; the charging adapter cannot be used to

power the label maker.

To recharge the battery

1 Plug the charging adapter into the

power connector on the top of the

label maker. See Figure 2.

2 Plug the other end of the charging

adapter into a power outlet.

Make sure to read the Li-ion Safety

Precautions found on page 8.

Inserting the Label Cassette

Your label maker uses DYMO D1 label

cassettes.

To insert the label cassette

1 Lift the back cover of the label maker to open the label compartment.

2 Make sure the tape and ribbon are taut across the

mouth of the cassette and that the tape passes

between the label guides. See Figure 3.

If necessary, turn the ribbon rewind spool

clockwise to tighten the ribbon.

3 Insert the cassette with the label facing out and

positioned between the label guides. See Figure 3.

4 Press firmly until cassette clicks into place. See

Figure 4.

5 Close the back cover.

Figure 2

Label

guides

Ribbon

rewind

spool

Figure 3

Figure 4

Click!

1 2 3 4 5 6 7 8 9 10 ... 13 14

Sem comentários

Samsung LabelManager Series Guia do Utilizador Página 5