Samsung C61RAAST Manual do Utilizador

Installation and Operating Instructions Ceramic Glass HobC61RAAST / C61RABAL / C61RACN / C61RADSTTo avoid the risk of accidents or damage to the hob,

8ENInstalling the Hob (Continued)Model : C61RABAL, C61RACN, C61RADSTx4902100100490+1==C61RAAST_EN.indd 8 2006-09-07 ¿ÀÈÄ 12:00:22

9ENInstalling the Hob (Continued)Model : C61RAAST x4902100100490+1==C61RAAST_EN.indd 9 2006-09-07 ¿ÀÈÄ 12:00:40

10ENParts and FeaturesCooking zones and control panel148 mm148 mm183 mm183 mmSingle cooking zone 1200 W Casserole cooking zone 1800 WSingle cooking zo

11ENComponents1 Ceramic Glass Hob2 Instruction Manual3 Installation Brackets4 Screws5 ScraperParts and Features (Continued)C61RAAST_EN.indd 11 2006-

12ENParts and Features (Continued)The key features of your appliance• Ceramic glass cooking surface: The appliance has a ceramic glass cooking surfac

13ENParts and Features (Continued)Safety shutoffIf one of the cooking zones is not switched off or the heat setting is not adjusted after an ex-tended

14ENHob UseUsing suitable cookwareBetter pans produce better results.• You can recognise good pans by their bases. The base should be as thick and fla

15ENHob Use (Continued)• Always position pots and pans before switching on the cooking zone.• Dirty cooking zones and pan bases increase power consump

16ENHob Use (Continued)Switching the appliance onTouch the “Lock ” sensor for approximately 3 seconds.The appliance is switched on using the “On / Of

17ENHob Use (Continued)Switching the appliance offTo completely switch off the appliance, use the “On / Off ” control sensor.Touch the “On / Off ” s

C61RAAST_EN.indd 2 2006-09-07 ¿ÀÈÄ 12:00:01

18ENUsing the child safety lockYou can use the child safety lock to safeguard against unintentionally turning on a cooking zone and activating the coo

19ENHob Use (Continued)Switching the child safety lock off1. Touch the control sensor for approximately 3 seconds. An acoustic signal will sound as c

20ENHob Use (Continued)Locking and unlocking the control panelAt any stage during the cooking process, the control panel, with the exception of the “O

21ENCleaning and CareHob Important: Cleaning agents must not come into contact with a heated ceramic glass surface: All cleaning agents must be r

22ENProblem Dirt1. Remove burnt-on sugar, melted plastic, aluminium foil or other materials with a glass scraper immediately and while still hot. I

23ENWarranty and ServiceFAQs and troubleshootingA fault may result from a minor error that you can correct yourself with the help of the following ins

24ENWarranty and Service (Continued)What does it mean when the burner does not glow red?• The selected temperature of the cooking zone is maintained

25ENTechnical Data Appliance dimensionsWidth 575 mmDepth 505 mmHeight 55 mmWorktop cut - out dimensionsWidth 560 mmDepth 490 mmCorner radius

26ENNoteC61RAAST_EN.indd 26 2006-09-07 ¿ÀÈÄ 12:01:05

27ENNoteC61RAAST_EN.indd 27 2006-09-07 ¿ÀÈÄ 12:01:05

1ENContentsUsing This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Safety .

Code No.:DG68-00061AC61RAAST_EN.indd 28 2006-09-07 ¿ÀÈÄ 12:01:05

2ENUsing This ManualPlease take the time to read this owner’s manual, paying particular attention to the safety information contained in the following

3ENSafety The safety aspects of this appliance comply with accepted technical standards and the German Appliance Safety Law. However, as manufacture

4ENSafety during use• This appliance is to be used only for normal cooking and frying in the home. It is not de-signed for commercial or industrial u

5ENInstalling the Hob Important: Be sure the new appliance is installed and grounded only by qualified personnel. Please observe this instruction.

6ENInstalling the Hob (Continued)Connecting to the mains power supplyBefore connecting, check that the nominal voltage of the appliance, that is, the

7ENInstalling the Hob (Continued)Installing into the countertop Make a note of the serial number on the appliance rating plate prior to installation