Samsung RB2155SW Especificações descarregar pdf (Página 17)

Mechanical Disassembly

Evaporator in Freezer

Accumulator

Thermistor

Thermal

Fuse

Evaporator is located in the bottom of freezer to

produce cold air driven across the evaporator coils.

1. Take off the ductwork in Freezer.

2. Disconnect the wire connector (Heater,

Bimental, and Thermistor).

3. Desolder the inlet and outlet tubes.

4. Remove the evaporator.

5. Take the same steps to seal the system as

mentioned earlier.

Evaporator is located in the bottom of refrigerator.

1. Take off the ductwork in refrigerator.

2. Disconnect the wire connector.(Heater and

Thermistor)

3. Desolder the capillary tube and the suction line

from the evaporator.

4. Remove the evaporator.

5. With a file, score the capillary tube just

upstream of the soldered point. Break off the

soldered section to help prevent solder from

plugging the tube during soldering.

6. Place a new evaporator and braze the suction

and capillary tube to evaporator using silver

solder.

7. Install a replacement dryer.

8. Evacuate and recharge the system using

reasonable procedures.

Evaporator in Refrigerator

Thermal

Fuse

Thermistor

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

Sem comentários

Samsung RB2155SW Especificações Página 17