Samsung SONOVET R5 Manual do Utilizador descarregar pdf (Página 136)

5-18

Operation Manual

Volume Measurement

3 Distance

This is a basic measurement that is available in all diagnosis modes. You can measure the volume of an ob-

ject in a 2D image by using 3 straight lines.

1. Use the Softmenu switch [3] Volume to select 3D Volume: 3 Distance. “3D Volume: 3 Distance” is

displayed on the left side of the screen.

2. Specify two points and measure the straight distance between them. The method for measuring a

line is the same as in “2D Distance (Line).”

3. Measure the length of the remaining two straight lines as in the above. Measure other two

distance using the same method with 2.

4. When the measurement is finished, its result is shown on the screen. The volume of the object

along with the length of each straight line are calculated.

The equations used for 3 Distance measurement are as follows:

X

, (D: distance)

1 Distance

This is a basic measurement that is available in all diagnosis modes. You can measure the volume of an ob-

ject in a 2D image by using only one straight line.

You can measure up to 4 sets of volumes. When measuring more than one set, use measurement cursors

with dierent shapes to dierentiate them.

1. Use the Softmenu switch [3] Volume to select 3D Volume: 1 Distance. “3D Volume: 1 Distance” is

displayed on the left side of the screen.

2. Specify two points and measure the straight distance between them. The method for measuring a

line is the same as in “2D Distance (Line).”

3. When the measurement is finished, its result is shown on the screen. The volume of the object

along with the length of the straight line are calculated.

The equations used for 1 Distance measurement are as follows:

X

, (D: distance)

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 167 168

Sem comentários

Samsung SONOVET R5 Manual do Utilizador Página 136