Samsung RF260BEAESP Manual do Utilizador Página 10

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 9
10_ setting up
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its fi nal location. Do not remove
the doors/drawer if you don’t need to. If you do
not need to remove the refrigerator doors, go to
Adjusting the Level on page 12. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
screwdriver(+)
Flat-blade screw
driver(-)
Socket wrench
(10 mm)
Pliers
Allen wrench
(5 mm)
Disconnect power to the refrigerator before
removing the door or drawer.
• Be careful not to drop, damage or
scratch the door/drawer while removing
them.
Be careful not to get injured while removing the
door/drawer.
Reattach the door/drawer properly to avoid:
Moisture from air leakage. -
Uneven door alignment. -
Wasting energy due to improper door seal. -
WARNING
Disassemble the refrigerator doors
Be careful not to drop and scratch the
doors while removing the doors.
With the door opened
Remove 3 screws holding down the TOP 1.
TABLE ( 1 ) and turn it with wires connected.
Disconnect two connector ( 2. 2 ) on the left side
door. To remove the water coupler from the
hinge, twist and pull it from the hinge.
Pull and remove the hinge lever ( 3. 3 ).
Remove the ground screw ( 4 ) attached
to the upper left door hinges with a philips
screwdriver (+). Remove the upper left and
right door hinges ( 5 ).
Lift the door straight up to remove.4.
WARNING
2
1
3
4
5
DA68-02616B(0.0).indb 10DA68-02616B(0.0).indb 10 2012.6.15 7:47:27 PM2012.6.15 7:47:27 PM
Vista de página 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 79 80

Comentários a estes Manuais

Sem comentários