Samsung SSC-2000 Manual do Utilizador

System KeyboardSSC-2000 User's ManualGBFDESIRP

English small letter input page will appear.Press “TEXT” if you want to enter large letters.Press “NUMBER” if you want to enter numbers.Press “SYMBOL”

CAMERA MENU Press the “SETUP” ICON on left below to control the menu of theselected camera.Using the direction key and the enter key, control the CAME

MUX channel selection1. Press the “CH” ICON below on the MUX screen.2. A channel selection screen will appear as shown below.3. Select the channel you

ADDRESS SETThe address of the system keyboard can be set.Press “ADDRESS SET” and the keyboard address input window willappear as shown below.Enter the

PARITY CHECKThe PARITY BIT of RS-232 communication can be set.Press “PARITY CHECK” and a pop-up window will appear as shownbelow.Select one among None

- Operator No. : Newly registered use's number - Password : New password is displayed.(******)- Operator Level : Th

UPLOAD progress screenWhen you press “OK” on the UPLOAD check screen, UPLOADprogress screen will appear as shown below.‘Complete’ message will appear

Chapter 7. Product Specification ITEM DESCRIPTIONINTERFACE (RS-485) CONNECTOR TYPE : 4PTERMINAL TYPEPORT : 1 PORTBAUD RATE : 4,800/9,600/19,200/38,400

This symbol indicates high voltage is presentinside. It is dangerous to make any kind ofcontact with any inside part of this product.This symbol alert

ContentsChapter 1. General Facts ...gb-3Introduction ...

GB-4B. Camera movement key - PRESET- PATTERN- SCAN- AUTO PANC. Alarm release key D. Joystick controller (UP/DOWN/LEFT/DOWN/AF/ZOOM)The Pan/Tilt connec

• Be sure to check dangers, which may occur due to damped floor,ungrounded power extension cable, worn power cord or lack of safetygrounding.CautionWh

GB-6• In case of connecting with Full Duplex- Connect the Txd (+) of Dome Camera RS-485 port with the Rx (+) ofSSC-2000.- Connect the Txd (-) of Dome

GB-77) Connecting PC based DVR(Applicable to the SPR Smart View V2.3 over)- Connect SSC-2000 through the RS-485 port in the back of PC BASEDDVR.- Conn

GB-8Chapter 4. Instructions Log-in1. Turn on the power of all the components of the system.2. When the power is applied by connecting the power adapte

GB-9PATTERN movementThis function is to view the camera movement for 30 seconds desig-nated by the user on the pattern mode of the camera menu. Press